Bernard Controls AT SWITCH RANGE User Manual

English
19
5.7 Heating resistance
Each actuator includes a heating resistance.
As soon as the actuator is installed in the field, it is required to
supply the resistance to prevent condensation.

• Immediately put the cover back in place after start-up while
ensuring its seal is clean. Never leave the electrical
components of the actuator without their protective cover.
In case of water intrusion:
• Dry the electrical components before putting back the cover.
• Check the electrical insulation.

Bernard Controls AT SWITCH RANGE Specifications

General

Brand	Bernard Controls
Model	AT SWITCH RANGE
Category	Controller
Language	English