10
7/27/11
All-Over Directional Stitching
This exercise, for the BERNINA 830 only, features an all-over
design created by selecting one stitch and changing directions
as you sew.
Twisted Scrolls
Place stabilizer behind fabric; mark parallel guide lines about 1”
apart on the fabric as a reference for guiding during the stitching
process.
Select 225º on the compass, Pattern Repeat 1x and Needle Stop
Down. Stitch one stitch pattern and stop; do not remove
the fabric.
Select 135º on the compass, leaving Pattern Repeat 1x and Nee-
dle Stop Down engaged. Stitch one stitch pattern and stop; do not
remove the fabric.
Stitch from one end of the fabric to the other, guiding fabric
so that the “+” stays parallel and perpendicular to the presser
foot.
Stitch additional rows of this stitch combination, covering the
surface of the fabric.
Note: Some adjustments may be necessary depending on the fabric,
thread, and stabilizer used to create the stitch sample.
Optional: Create a 4-sided motif by selecting 315º and 45º as
the third and fourth sides.
Fabric: Firm woven fabric, 4” x 6” and
Heavyweight tear-away stabilizer, 4” x 6”
Needle: 80/12 Universal
Thread: 30 wt. cotton embroidery
Needle Position: center
BERNINA Presser Foot: Sideways Motion Foot #40C
Do you know how to:
▪ Change directions in 45º increments
when Multi-Directional stitching?
BERNINA 830 only
To Next Page
Loading...
Need help?
General
