11
7/27/11
All-Over Directional Stitching
Fabric: Firm woven fabric, 4” x 8” and
Heavyweight tear-away stabilizer, 4” x 8”
Needle: 80/12 Universal
Thread: 30 wt. cotton embroidery
Needle Position: center
BERNINA Presser Foot: Sideways Motion Foot #40C
This exercise has two decorative stitches programmed into memory
and stitched in rows. The tulip/leaf designs are connected by direc-
tional straight stitches to vary their positions as they are stitched.
The artista 730 requires the programming of the connecting stitches
(Straight stitch #39) but the BERNINA 830 will add the stitches
automatically once you select the Connecting stitches icon.
Trailing Tulip Vines
Place stabilizer behind fabric; mark parallel guide lines about 1” apart
on the fabric as a reference for guiding during the stitching process.
artista 730
Program the following stitches in Combi Mode:
- stitch #137; Up/Down Mirror Image
- stitch #145
- stitch #39, direction 6 - 1x
- stitch #145; Up/Down Mirror Image
- stitch #137
- stitch #39, direction 10 - 1x
- stitch #145; Up/Down Mirror Image
- stitch #137
- stitch #39, direction 6 - 1x
- stitch #137; Up/Down Mirror Image
- stitch #145
- stitch #39, direction 10 - 1x
Save the combination.
Stitch from one end of the stabilized fabric to the other, using
fingertip guiding to keep the presser foot parallel to the
drawn guidelines.
Stitch additional rows of this stitch combination, scrolling
through the stitches to start at different points.
Note: Some adjustments may be necessary depending
on the fabric, thread, and stabilizer used to create the
stitch sample After stitching the first line, examine the
results and make adjustments as necessary.
Do you know how to:
▪ Add Directional stitches to a stitch
combination?
artista 730 only
To Next Page
Loading...
Need help?
General
