14
Y
ou can specify the settings as follows:
1. Shiatsu back massage
The device automatically begins the Shiatsu massage for the entire back area immediately after being turned
on. Then, if needed, press the upper back or lower back button to select the desired massage area.
2. Demo run
P
ress the demo button to begin a quick 5-minute run-through of the functions contained in the device. The
manual controller indicates which function is being displayed by flashing the respective LED. The device
switches off automatically once the demo run has finished.
3. Neck massage
P
ress the neck button to start the neck massage. Press neck (anti-clockwise rotation) or neck (clock-
wise rotation) to change the direction of the massage.
4. You can choose a spot massage, i.e. a Shiatsu massage with minimal vertical movement by pressing the
spot
button. You can change the position of the spot massage by holding down one of the two arrows next
to the
spot
button until the desired position is reached.
5. Air compression massage
For the compressed air massage, 3 different massage intensities are available, which can be selected using
the intensity button. Firstly, press the air back and/or air seat button to switch to compressed air massage,
and then to set your desired intensity:
Level 1: left LED lights up
Level 2: right LED lights up
Level 3: both LEDs light up
Once it has been activated, the compressed air massage will begin at the lowest intensity level.
6
. Heat function
Y
ou can activate the heat function of the massage heads by pressing the heat button. The blue illuminated
massage heads will turn red.
•
Use the massager for max. 15 minutes and then leave it to cool down. Long massages can lead to over-stim-
ulation of the muscles, creating tension instead of aiding relaxation. You can end the massage at any time
by pressing the
button. Please note that the massage heads will return to their start position in the lumbar
area when the device is switched off. This is indicated by a flashing LED light. Once this position is reached,
the device switches off.
•
If the device is stopped by pressing a massage area button twice, it will also return to the start position
after the timer ends and switch itself off.
•
Do not disconnect the device from the power supply while it is in operation. Always switch it off first and
then wait until it has reached its initial position.
Note
•
The device features an automatic switch-off function, which is set to the maximum operating du-
ration of 15 minutes.
8. Maintenance and storage
Cleaning
WARNING
•
Unplug the device each time before cleaning.
•
Clean the device using only the methods specified. Under no circumstances may liquid enter the
device or the accessories.
•
Small marks can be removed using a cloth or damp sponge, and some liquid delicate laundry de-
tergent where necessary. Do not use any solvent-based cleaning products.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
