Radiomode/CD/MP3/WMA/iPod mode
Changing to CD/MP3/WMA/iPod
mode
Press the SRC
@
repeatedly until the
desired audio source is displayed:
• "CD": Inserted CD.
• "SD(HC)": Inserted memory card
• "USB FRONT" or "USB REAR": USB data
carrier connected to the front or rear.
• "IPOD FRONT / IPHONE FRONT" or "IPOD
REAR / IPHONE REAR": Connected iPod /
iPhone at the front or rear side
• "AUX": Connected external audio source.
Notes:
• The respective audio source can be select-
ed only if a corresponding CD is inserted or
a corresponding device is connected.
rst has to read
the data of a connected device or data car-
rier before the playback, the display shows
"READING". The duration of the reading
depends on the data volume and design
of the device or data carrier. If the device
or data carrier is defective or the trans-
ferred data cannot be played back, a corre-
sponding message appears on the display
(e.g. "CD ERROR").
Inserting/ejecting a CD
Inserting a CD
Risk of severe damage to the CD
drive!
Noncircular contoured CDs (shape CDs)
and CDs with a diameter of 8 cm (mini CDs) must
not be used.
We accept no responsibility for any damage to the
CD drive that may occur as a result of the use of
unsuitable CDs.
Note:
You must not hinder or assist the drive as it
automatically draws in the CD.
Insert the CD with its printed side up into the
CD tray
5
until you feel a slight resistance.
The drive automatically draws in the CD and
checks its data. Afterwards, the playback
starts in CD or MP3 mode.
Note:
If the inserted CD cannot be played back, "CD
y displayed and the CD is au-
tomatically ejected after approx. 2 seconds.
y shows "SEARCH AUTO".
The radio tunes into the next receivable sta-
tion.
Notes:
• For the reception area "EUROPE": In the FM
c information stations
c infor-
mation (
) is switched on.
• The sensitivity of seek tuning can be ad-
justed (see the chapter "User settings",
section "Making settings in the "TUNER"
menu", menu item "SENSITIVITY").
Tuning into stations manually
Press the rotary button
7
once to activate
manual station tuning.
y shows "SEARCH MANUAL".
7
to change the fre-
quency in increments.
Note:
The manual station tuning is automatically
exited approx. 15 seconds after the last fre-
quency change, and the station seek tuning is
started by turning the rotary control
7
.
Storing stations or calling stored
stations
Select the desired memory bank.
If necessary, set the desired station.
Press the station button 1-5
>
for approx.
2 seconds to store the current station under
the button.
- or -
y press the station button 1-5
>
to call
up the stored station.
To Next Page
Loading...
Need help?
General
