6
Placing the device in operation
Attaching the control panel
쏅 Push the control panel into the bracket at the
right edge of the device.
쏅 Push the control panel carefully into the left
bracket until it clicks into place.
Removing the control panel
쏅 Press the
button
1
to unlock the control
panel.
The left side of the control panel detaches
from the device and is secured by the bracket
against falling out.
쏅 Move the control panel slightly to the left
until it disengages from the right bracket.
쏅 Carefully remove the control panel from the
left bracket.
Note:
The car sound system automatically switches
o as soon as the control panel is removed.
Setting the reception area
This car sound system is designed for operation in
di erent regions with di erent frequency ranges
and station technologies. The factory default of
the reception area is "EUROPE". In addition, the re-
ception areas "USA", "S-AMERICA" and "THAILAND"
are available.
Note:
If you operate the car sound system outside of
Europe, you may rst have to set a suitable re-
ception area in the user menu (see the chap-
ter "User settings", section "Making settings in
the "TUNER" menu", menu item "AREA").
Switching on/o
Switching on/o with the On/O button
쏅 For switch-on, press the On/O button
3
.
The car sound system switches on.
쏅 To switch o the device, press and hold down
the On/O button
3
for longer than 2 sec-
onds.
The car sound system switches o .
Note:
If you switch on the car sound system while
the vehicle ignition is switched o , it auto-
matically switches o after 1 hour to preserve
the vehicle battery.
Switching on/o via vehicle ignition
The car sound system will switch o /on simulta-
neously with the ignition if the device is correctly
connected to the vehicle’s ignition as shown in the
installation instructions and you did not switch
the device o by pressing the On/O button
3
.
Volume
Adjusting the volume
You can adjust the volume in steps from 0 (o ) to
50 (maximum).
쏅 Turn the volume control
4
to change the
volume.
Note:
(London 120 and Melbourne 120)
If a telephone is connected with the car sound
system as described in the installation instruc-
tions, the car sound system is muted in case
of a phone call. During muting, the display
shows "TELEPHONE".
Muting the car sound system (Mute)
쏅 Brie y press the On/O button
3
to mute
the car sound system or to reactivate the pre-
vious volume.
During muting, the display shows "MUTE".
Switching demo mode on/o
The demo mode shows the functions of the car
sound system as scrolling text on the display. You
can turn the demo mode on or o :
쏅 Switch o the car sound system if it is not
already turned o .
London 120 and Melbourne 120
쏅 Press and hold the buttons
7
and 6
>
at the same time and press the On/O but-
ton
3
.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
