To Next Page

To Previous Page

2 11

RESmart

Heated Humidifier User Manual V2.6

The RESmart

Integrated Heated Humidifier is designed only for use with specific BMC

RESmart

CPAP/Auto CPAP or BPAP devices. Do not use this humidifier with any other

devices.

The humidifier moistens the air delivered by the BMC RESmart

CPAP/BPAP devices.

The Heated Humidifier is only used for single patient and must not be re-used on another

person. This is to avoid the risk of cross-infection.

The Heated Humidifier is not intended for use with a patient whose upper airways have been

bypassed.

Table of Contents

Warnings & Cautions .......................................... 2

Symbols ............................................................... 2

Features ............................................................... 3

Set Up ................................................................... 4

Daily Use .............................................................. 5

Cleaning ............................................................... 6

Service ................................................................. 6

Specifications ...................................................... 7

Disposal ............................................................... 7

Traveling .............................................................. 8

EMC Requirements ............................................. 9

Warranty ............................................................... 12

RESmart

, InH2 are registered trademarks of BMC Medical Co., Ltd.

RESmart

Heated Humidifier User Manual V2.6

P12

Guidance and manufacturer's declaration - electromagnetic immunity

The RESmart is intended for use in the electromagnetic environment specified below. The user of the

RESmart should make sure that it is used in such an environment.

Immunity test

IEC 60601 test

level

Compliance

level

Electromagnetic environment - guidance

Conducted RF

IEC 61000-4-6

Radiated RF

IEC 61000-4-3

3 Vrms

150 kHz to 80

MHz

3 V/m

80 MHz to 2.5

GHz

3 Vrms

3 V/m

Portable and mobile RF communications

equipment should be used no closer to any part of

the RESmart, including cables, than the

recommended separation distance calculated

from the equation applicable to the frequency of

the transmitter.

Recommended separation distance

d=1.2√P

d=1.2√P 80 MHz to 800 MHz

d=2.3√P 800 MHz to 2.5 GHz

where P is the maximum output power rating of

the transmitter in watts (W) according to the

transmitter manufacturer and d is the

recommended separation distance in meters (m).

Field strengths from fixed RF transmitter, as

determined by an electromagnetic site survey,

should be less than the compliance level in each

frequency range.

Interference may occur in the vicinity of equipment

marked with the following symbol:

NOTE 1: At 80 MHz and 800 MHz, the higher frequency range applied.

NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by

absorption and reflection from structures, objects and people.

Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones

and land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be

predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed RF

transmitters, an electromagnetic site survey should be considered. If the measured field strength in the

location in which the RESmart is used exceeds the applicable RF compliance level above, the RESmart

should be observed to verify normal operation. If abnormal performance is observed, additional

measures may be necessary, such as re-orienting or relocating the RESmart.

Over the frequency range 150 kHz to 80 MHz, the field strengths should be less than 3 V/m.