RESmart
©
Heated Humidifier User Manual V2.6
P6
Daily Use
1. Fill the chamber to the fill line with water (approx. 350 ml) from the outlet port. Distilled water is recommended. Do not
overfill the water chamber.
CAUTION! Always remove the chamber from the humidifier before filling with water.
2. Press down the spring loaded heater plate with the water chamber and slide the chamber into place. Make sure the rubber
connector on the inlet port fits securely over the RESmart device’s air outlet.
3. Connect the flexible tubing to the outlet port on the water chamber.
CAUTION! Avoid moving or tilting the humidifier when the water chamber has water in it.
4. Press the humidifier button on the RESmart device after CPAP is blowing. The humidifier key will be lighted and the
yellow indicator light on the humidifier will turn on.
5. The ideal humidity setting depends on room temperature and humidity. Initially, a setting of 3 is recommended. You can
adjust this setting at any time. Please adjust the humidifier setting according to the CPAP User Manual.
IMPORTANT! When the air flow is turned off, the humidifier will automatically shut off. If you restart
the air flow within 30 minutes, the humidifier will be reactivated automatically.
RESmart
©
Heated Humidifier User Manual V2.6
P7
Cleaning
The water chamber should be cleaned daily or after each use.
WARNING! Emptying and cleaning the water chamber daily will help to prevent mold and bacteria
growth.
WARNING! Allow the water in the chamber to cool down to room temperature before removing it from
the humidifier.
WARNING! To avoid electrical shock, disconnect the power cord of RESmart device before cleaning
the humidifier. DO NOT immerse the humidifier into any fluids.
Water Chamber
1. Turn the RESmart device off and allow approximately 15 minutes for the heater plate and water to cool.
2. Disconnect the tubing from the water chamber. Press down on the water chamber and slide it out of the humidifier
platform.
3. Open the silica gel cover of water chamber and discard any remaining water. Fill a solution of warm water and a mild
dishwashing detergent into the chamber, cover the silica gel cover, rock the chamber a few minutes, and then outflow the
solution. Rinse the chamber several times with clean water and allow to air dry.
4. Fill the water chamber and close the silica gel cover. Inspect the water chamber for any leak or damage. Replace the
water chamber if any damage is present.
Humidifier Platform
1. Clean the humidifier platform by wiping with a damp cloth. Allow to air dry.
2. Inspect the humidifier platform for any damage and replace if necessary.
Silicone Tube of Humidifier
1. Clean the Silicone Tube by wiping with an alcohol cotton stick. Allow to air dry.
Service
The humidifier does not require routine servicing.
If the humidifier malfunctions, contact your home care provider immediately. Never attempt to open the
humidifier’s enclosure. If necessary, contact your local authorized dealer or BMC Medical Co., Ltd. for technical
support and documents.
To Previous Page
Loading...
Need help?
General
