EasyManuals Logo

BMW 2012 X1 User Manual

BMW 2012 X1
291 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #116 background imageLoading...
Page #116 background image
Observe the instructions concerning the
safety belt
Observe the instructions concerning the safety
belt, refer to page 45. Otherwise, personal pro‐
tection may be compromised.◀
Outside backrests
1. Reach into the recess and pull the lever to‐
ward the front.
2. Engage the backrest in the desired position
or fold it down.
On the left side, the outer and center backrests
are adjusted jointly toward the front if both back‐
rests are engaged in the same lock-in position.
The backrests can be adjusted separately to‐
ward the rear. Note that the center backrest can‐
not be tilted farther down than the left backrest.
Center backrest only
1.
Pull the loop, arrow.
2. Engage the backrest in the desired position
or fold it down.
Folding the backrests back up
When the backrests are folded back up, they
engage in the transport position.
To set the desired backrest tilt or comfort posi‐
tion, pull the lever of the left/right backrest or the
loop of the center backrest forward.
Locking the backrest
Before letting passengers ride in the rear,
engage the seat backrests, locking them in
place. Otherwise, there is the danger of an ac‐
cident due to unexpected seat movement.◀
Partition net
Firmly attach the partition net
Make sure that the partition net is firmly
attached; otherwise, injuries may result.◀
The partition net can be attached behind the
front or rear seats.
Before installing
1.
Remove the pouch with the partition net
from the storage compartment under the
cargo floor panel in the cargo area.
2. Take the partition net out of the pouch, un‐
roll it, and unfold it.
After use, fold and roll up the partition net in
the same manner and place it in the pouch
so that it can be stowed back under the
cargo floor panel.
Ensure that hooks and tensioning buckles
do not rest on the rod elements.
3. Unfold the partition net to the point where
the rod elements engage.
Mounting eyes
Four mounting eyes are located on the back of
the rear seat backrests.
Seite 116
Controls Interior equipment
116
Online Edition for Part no. 01 40 2 914 595 - VI/12

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BMW 2012 X1 and is the answer not in the manual?

BMW 2012 X1 Specifications

General IconGeneral
BrandBMW
Model2012 X1
CategoryAutomobile
LanguageEnglish

Related product manuals