Mounted luggage systems
such as a topcase
Tampering
ATTENTION
Tampering with the E-
Scooter
Damage to the affected parts,
failure of safety-relevant func-
tions. Damage due to tampering
is not covered by the warranty.
Do not tamper with the vehicle
in any way that could result in
tuned performance.
Comply with checklist
At regular intervals, use the
checklist below to check your
E-Scooter.
Requirement
Always before riding off:
Check the state of charge of
the high-voltage battery.
Check operation of the brake
system.
Check operation of the lights
and signalling equipment.
Checking tyre tread depth
( 103).
Check that topcase and lug-
gage are securely fastened.
Requirement
Every 10th recharge:
Adjusting spring preload for
spring strut ( 57).
Checking front brake pad thick-
ness ( 97).
Check rear brake pad thickness
( 98).
Check the brake-fluid level,
front brakes ( 100).
Checking brake-fluid level, rear
brakes ( 101).
Check coolant level ( 102).
Starting
Pre-Ride-Check
The instrument cluster runs a
test of the display and the in-
dicator and warning lights when
operational readiness is switched
on. This test is known as the
Pre-Ride-Check. It consists of
2 phases. The Pre-Ride-Check
is aborted as soon as the brake
is applied or the starter button
pressed.
Phase 1
The 'general' warning light and
the symbol for the electrical ma-
chine electronics show red.
The 'reserve' light shows yellow.
Phase 2
The 'general' warning light and
the symbol for the electrical ma-
chine electronics change from
red to yellow.
As soon as the sequence of im-
ages reaches the end the ori-
7
79
z
Riding
To Next Page
Loading...
Need help?
General
