Tyres
New tyres have a smooth sur-
face. This must be roughened by
riding in a restrained manner at
various heel angles until the tyres
are run in. This running in pro-
cedure is essential if the tyres are
to achieve maximum grip.
WARNING
New tyres losing grip on wet
roads and at extreme bank
angles
Risk of accident
Ride carefully and avoid ex-
tremely sharp inclines.
Brakes
How can stopping
distance be minimised?
Load distribution shifts dynam-
ically between the front and rear
wheels when the vehicle brakes.
The sharper the vehicle decel-
erates, the more load is shifted
to the front wheel. The higher
the wheel load, the more braking
force can be transmitted without
the wheel locking.
To optimise stopping distance,
apply the front brakes rapidly and
keep on increasing the force you
apply to the brake lever. This
makes the best possible use of
the dynamic increase in load at
the front wheel. When high brak-
ing pressure is applied sharply
the dynamic shift in load distri-
bution cannot keep pace with
the increase in deceleration and
the tyres cannot transmit the full
braking force to the surface of
the road.
Descending mountain
passes
WARNING
Braking only with the rear
brake on mountain descents.
Brake fade. Destruction of the
brakes due to overheating.
Use both front and rear brakes,
and make use of the energy
recovery function as well.
Wet and dirty brakes
Wetness and dirt on the brake
discs and the brake pads dimin-
ish braking efficiency.
Delayed braking action or poor
braking efficiency must be
reckoned with in the following
situations:
Riding in the rain or through
puddles of water.
After the vehicle has been
washed.
Riding on salted or gritted
roads.
After work has been carried on
the brakes, due to traces of oil
or grease.
Riding on dirt-covered surfaces
or off-road.
7
85
z
Riding
To Next Page
Loading...
Need help?
General
