Phase 3
The rev. counter and speedo-
meter needles both swing to
the starting position on their
scales. At the same time, all the
warning lights and telltale lights
switched on in the initial phase
are switched off in reverse se-
quence.
If a needle did not move or if a
warning light or telltale light did
not show:
Have the fault rectified as
quickly as possible by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
ABS self-diagnosis
BMW Motorrad ABS performs
self-diagnosis to ensure its op-
erability. Self-diagnosis is per-
formed automatically when you
switch on the ignition. The mo-
torcycle has to move forward a
few metres for the wheel-speed
sensors to be tested.
Phase 1
Test of the diagnosable system
components with the vehicle at a
standstill.
ABS warning light flashes.
Phase 2
Test of the wheel-speed sensors
as the vehicle pulls away from
rest.
ABS warning light flashes.
ABS self-diagnosis
completed
The ABS warning light goes out.
Make sure that all the warning
and telltale lights come on in
the pre-ride check.
After the ABS self-diagnosis
completes, an indicator show-
ing an ABS fault will appear.
You can continue to ride. Bear
in mind that the ABS function
is not available.
Have the fault rectified as
quickly as possible by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
Running in
Engine
Until the first running-in check,
vary the throttle opening and
engine-speed range frequently;
avoid riding at constant engine
rpm for prolonged periods.
Try to do most of your rid-
ing during this initial period on
twisting, fairly hilly roads, avoid-
ing high-speed main roads and
highways if possible.
5
55
z
Riding
ProCarManuals.com
To Next Page
Loading...
Need help?
General
