Apply uniform pressure to push
the front-wheel stand down
and raise the motorcycle.
with centre stand
OA
If the motorcycle is raised
too far the centre stand will
lift clear of the ground and the
motorcycle could topple to one
side.
When raising the motorcycle,
make sure that the centre stand
remains on the ground. If ne-
cessary, adjust the height of the
front-wheel stand.
Make sure the motorcycle is
standing firmly.
Lighting
Replacing bulbs for low-
beam headlight and high-
beam headlight
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove cover 1 for the high-
beam headlight or cover 2 for
the low-beam headlight.
Disconnect plug 3.
Disengage spring clips 4 from
the fastenings and swing them
aside.
Remove bulb 5.
8
95
z
Maintenance
ProCarManuals.com
To Next Page
Need help?
General
