To Next Page

To Previous Page

Tighten small screws 1 to the

specified tightening torque.

Handlebar clamping

block

19 Nm

A gap remains between the

handlebar clamping blocks

on the side where the small

screws are located.

Adjusting handlebar tilt

Slacken small screws 1.

Slacken large screws 2.

Align the mark for the appropri-

ate angle of tilt with notches 3.

Tighten large screws 2 to the

specified tightening torque.

Handlebar clamping

block with handlebars to

fork bridge

38 Nm

Make sure that there is no gap

between the handlebar clamp-

ing blocks on the side where

the large screws are located.

If necessary, slacken screws 1

and retighten screws 2 to the

specified tightening torque.

Tighten small screws 1 to the

specified tightening torque.

Handlebar clamping

block

19 Nm

A gap remains between the

handlebar clamping blocks

on the side where the small

screws are located.

Operation

Other manuals for BMW G 450 X

Questions and Answers:

Need help?

Do you have a question about the BMW G 450 X and is the answer not in the manual?

General