Remove the cable tie from
cap 1.
With its built-in coded plug,
the motorcycle is no longer
approved for use on public roads.
Do not ride on public roads with
built-in coded plugs.
Activate increased engine
power by installing coded
plug 2 instead of cap 1.
Engine power rating
30 kW (without coded plug)
38 kW (with coded plug)
Before riding the motorcycle on
public roads, remove the coded
plug and install the cap.
Secure the plug with cable ties.
Hold the right side panel in po-
sition and install screws 1.
Possible ratios
The motorcycle comes complete
with a second pinion that can be
used to change the final-drive
gear ratio. Your authorised BMW
Motorrad dealer stocks other pin-
ions as spare parts. Always bear
in mind that the length of the
chain might have to be altered,
depending on the transmission
ratio selected.
With the final-drive trans-
mission ratio altered the
motorcycle is no longer compli-
ant with the regulations govern-
ing use on public roads.
Do not attempt to ride the mo-
torcycle on public roads with any
final-drive transmission ratio other
than the ex-works ratio.
The procedure for replacing the
pinion is described in the Repair
Manual on RepROM.
Before taking the motorcycle
onto a public road, always check
that the final-drive transmission
ratio corresponds to the ex-works
condition (see the section en-
titled "Technical Data").
5
51
z
Riding
To Next Page
Loading...
Need help?
General
