In particular, be sure to remove
dried dirt from bottom part 1
of the slider tubes. If neces-
sary for better access, remove
screws 2 and remove the fork
protectors.
Use a damp cloth to wipe
clean the right and left slider
tubes. In this process, be
sure to pull the cloth through
between the fork protector and
the slider tube at the front.
Push left and right sealing
boots 1 down.
Use a dry cloth to wipe dirt off
the sealing boots and slider
tubes.
Pack the groove of each seal-
ing boot with grease.
Molykote 111
Slide the sealing boots back up
into position.
Spring strut
Cleaning spring strut
Use plenty of clean water
(garden hose) to rinse off dirt
and foreign matter.
Clean the spring strut with a
gentle cleaning agent.
Push up rubber stop 1 and
clean the part of the strut nor-
mally covered by the stop.
After cleaning it, spray the
spring strut with oil.
Penetrating oil
Bulbs
General instructions
A defective bulb places
your safety at risk because
it is easier for other users to
oversee the motorcycle.
Replace defective bulbs as
soon as possible; always carry a
complete set of spare bulbs if
possible.
The bulb is pressurised and
can cause injury if dam-
aged.
Wear protective goggles and
gloves when changing bulbs.
7
75
z
Maintenance
To Next Page
Need help?
General
