26
General information and controls
1
Distance recorder
L Note:
Distance recorder 2 appears only
when the ignition switch is in the
ON position.
Each time you switch on the igni-
tion the odometer reading showing
the total distance the motorcycle
has covered appears for
10 seconds, before the display
switches to the mode selected be-
fore the ignition was switched off.
d Warning:
Do not attempt to check/set the
distance recorder unless the
motorcycle is at a standstill
–Risk of accident.
• Ignition switch ON
•Press button1 for less than
2 seconds; each time you press
the button the display steps to
the next reading in the following
sequence:
– Odometer reading (total dis-
tance covered)
– Tripmeter 1 reading
– Press button 1 for longer
than 2 seconds if you want
to reset this reading.
– Tripmeter 2 reading
– Press button 1 for longer
than 2 seconds if you want
to reset this reading.
2
1
10LTbkg6.book Seite 26 Mittwoch, 16. Mai 2007 10:35 10
To Next Page
Loading...
Need help?
General
