49
R 1200 CL
PDI Procedures - Set Up
R 1200 CL Introduction
Make sure tool kit is complete
• Make sure the tool kit is complete.
Note the new unique R 1200 CL
tools included in the kit.
• Tire inflation shrader valve tool
• Ignition Coil removal tool
•90
O
bend phillips head screw
driver socket for removing rear
directional light lens covers.
• Radio Antenna wrench
• Install Antenna using special tool as
shown (from tool kit).
• Thoroughly wash motorcycle to
remove all transportation preserva-
tives.
• Inspect the motorcycle thoroughly
for damage and or missing parts. If
necessary, submit a QEW (MTAS).
• If parts are needed, order them.
Part costs are reimbursed via a
warranty claim using defect codes:
Parts missing - 10 01 00 00 00
Parts damaged- 10 02 00 00 00
Parts Incorrect - 10 03 00 00 00
• At this point you have completed the set up portion of the Pre Delivery
Inspection. Make sure an RO has been assigned to the PDI for the motor-
cycle and convey any information about missing or damaged parts to the
parts department and warranty administrator.
• Perform balance of Pre-delivery inspection checks as outlined on the Pre-
delivery check sheet sample on the next page. PDI checklists are accessed
online from the MTAS (Aftersales> Service> Technical Information). As a
time saving tip, print out multiple copies and store them for future R
1200 C models.
Install Antenna
To Next Page
Loading...
Need help?
General
