BMW R 1200 CL User Manual

54
R 1200 CL
PDI Procedures - Checking Brake Fluid Levels
R 1200 CL Introduction
Integral ABS has four separate brake
circuits. Fluid levels are checked at all
four of the following locations,
1. Handlebar mounted
ffrroonntt
brake
control circuit reservoir.
• Turn handlebars fully to the left.
• Check fluid level in sight glass.
• MIN level is as indicated.
• Top off with DOT 4 brake fluid as
necessary.
2. Right side frame mounted
rreeaarr
brake control circuit reservoir.
• With the motorcycle on its cen-
ter stand, check the level
through the window in the right
side trim panel
• Desired level is at the MAX line.
If necessary, add DOT 4 brake
fluid.The fluid level must not fall
below the MIN line.
Note: Fluid level remains constant in
control circuit reservoirs as pads wear.
Checking Front Brake Control Circuit Fluid Level
Checking Rear Brake Control Circuit Fluid Level
3. Integral ABS modulator
ffrroonntt
brake wheel circuit reservoir
4. Integral ABS modulator
rreeaarr
brake wheel circuit reservoir
• Checking the fluid level at these two locations is identical in process.
• Unscrew and remove the wheel circuit reservoir caps one at a time.
• Use a shoplight to clearly see the fluid level.
• Make sure no contaminant’s enter the brake fluid reservoir.
• Top off with DOT 4 brake fluid as necessary.
• Carefully reinstall caps. Do not overtighten.

BMW R 1200 CL Specifications

General

Brand	BMW
Model	R 1200 CL
Category	Motorcycle
Language	English