If the brake fluid level drops be-
low the permitted level:
Have the defect rectified as
quickly as possible by a spe-
cialist workshop, preferably
an authorised BMW Motorrad
dealer.
If the bottom edge of the black
diaphragm in the brake-fluid
reservoir is below the MAX mark:
Check the front brake pad
thickness ( 96).
Checking brake-fluid
level, rear brakes
A low fluid level in the
brake reservoir can allow air
to penetrate the brake system.
This significantly reduces braking
efficiency.
Check the brake-fluid level at
regular intervals.
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Remove the front seat ( 60).
Check the brake fluid level in
rear reservoir 1.
Wear of the brake pads
causes the brake fluid level
in the reservoir to sink.
Brake fluid level, rear
Brake fluid (DOT4)
Do not permit the brake fluid
level to drop below the MIN
mark. (Brake-fluid reservoir
horizontal, motorcycle up-
right)
If the brake fluid level drops be-
low the permitted level:
Have the defect rectified as
quickly as possible by a spe-
cialist workshop, preferably
an authorised BMW Motorrad
dealer.
8
100
z
Maintenance
ProCarManuals.com
To Next Page
Loading...
Need help?
General
