1 Information
1.1 Symbols used
Denotes instructions that draw your attention to dangers.
Denotes instructions that draw your attention to special features.
Denotes the end of the instruction or warning text.
1.2 Safety information
■
Read the safety information carefully and familiarise yourself with the device before you
attempt to install, operate or service it.
■
Danger from electricity. The BMW Wallbox must be installed, commissioned and serviced
by appropriately trained, qualified and authorised electricians
(1)
, who bear full responsibility
for complying with the current standards and installation regulations.
■
Please note that vehicles or national regulations may require additional overvoltage
protection. Please refer to your national connection and installation standards.
■
Check that all screw and clamp connections are secure before commissioning the device.
The terminal block must never be left open unattended. Fit the cover on the terminal block
if you leave the BMW Wallbox unattended during the installation work.
■
Do not make any unauthorised changes or modifications to the BMW Wallbox.
■
You must not carry out any repair work to the BMW Wallbox. Such work may only be
carried out by the manufacturer or a trained expert (for example replacing the BMW
Wallbox).
■
Do not remove any identifiers such as safety symbols, warnings, model plates, labels or
cable markings.
■
The BMW Wallbox does not have a main switch. The RCCB and circuit breaker on the
building installation are used as the mains isolator.
(1)
People who, as a result of their training, skills and experience and their knowledge of the
relevant standards can assess the work and identify possible dangers.
4
To Next Page
Loading...
Need help?
General
