Technical Specifications
10
Power Rating (RMS): . . . . . .PS60: 60 watts; PS120: 120 watts; PS240: 240 watts; PS600: 600 watts
Frequency Response: . . . . . .20 Hz to 20 kHz, +0/-2 dB @ -2 dB
Distortion: . . . . . .0.3% (typ.), 20 Hz to 20 kHz
Signal-to-Ratio Noise: . . . . . .Fundamental: -70 dB or better; AUX 1 & 2: -70 dB; TEL: -70 dB or better @ 600-ohms;
MIC 1 through MIC 6: -60 dB or better @ 200 ohms
Inputs/Outputs:
MIC: . . . . . .6 Lo-Z balanced via 4 XLR connectors and 2 pluggable screw terminals,
Sensitivity: 11mV (200 ohms
AUX: . . . . . .2 Hi-Z RCA jacks. Sensitivity: 0.085V (10k ohms)
TEL: . . . . . .Pluggable screw terminals. Sensitivity: 0.07V (600 ohms)
Power Amp In/Pre Out: . . . . . .In 1V/Out 1V via RCA jacks
Tape Output: . . . . . .700 mV @ Rated Output via RCA jack
Speaker Output: . . . . . .All models: 8-ohm, 25V/70V
Output Regulation: . . . . . .Better than 2 dB from no load to full load
AC Input Voltage: . . . . . .100-240VAC, 50/60 Hz
AC Current: . . . . . .PS60: 0.83A; PS120: 1.55A; PS240: 2.37A; PS600: 5.30A
Variable Mute Range: . . . . . .-60, -21, -10, 0 dB (AUX 1 & AUX 2)
ALC: . . . . . .Distortion: less than 0.5%; Compression: 25 dB (TEL)
VOX Threshold: . . . . . .TEL Input 20 mV (VOX control max. CW position)
MIC/AUX/TEL Precedence: . . . . . .Via pluggable screw terminals. -60 dB: MIC 1, 2, 3, 4, 5/TEL, 6/AUX 1, AUX 2
Power In/Pre Out: . . . . . .In 1V/Out 1V via RCA jacks
Phantom Power: . . . . . .13V DC
Lo-Cut: . . . . . .-3 dB @ 85 Hz
Loudness Contour: . . . . . .+8 dB @ 100 Hz, +4 dB @ 10 kHz (AUX 1 & AUX 2 control at 1/4 CW position)
Parametric Equalizer: . . . . . .5-bands with independent GAIN, FREQ and Q controls
Overload Protection: . . . . . .Electronic with automatic reset
Thermal Protection: . . . . . .Thermistor attached to heat sink
Dimensions: . . . . . .16-1/2” W x 3-1/2” H x 13-1/2” D
Shipping Weight: . . . . . .All Models: 14 lb.
To Next Page
Loading...
Need help?
General
