18
A.2 Connecting The OC-1 To The
Systems Controller
The rear panel of the systems controller should face
you. The internal harness should be inside.
1. Turn the OC-1 circuit board so the component
side faces you.
2. Insert the small white connector on the
internal harness into the J1 jack on the circuit
board (Figure 26). Match the fin on top of the
connector to the slot on top of the jack.
3. Insert the circuit board into the multipin
receptacles inside the systems controller (Figure
27). The component side faces you. The J1 jack
is on the left side. Press gently to seat both plugs
firmly in the receptacles. Do not force.
NOTE: If you install the OC-1 backwards it won’t fit
properly and the interior harness won’t reach the jack.
4. Replace the controller cover. Slide the lip on the
front edge of the cover under the controller front
panel.
5. Replace the four screws in the controller cover.
Tighten firmly.
Figure 26
Connecting the OC-1 circuit board to the systems controller.
Figure 27
Seat the OC-1 plugs into the receptacles inside the systems controller.
To Next Page
Loading...
Need help?
General
