EasyManuals Logo
Home>Bose>Speaker System>Companion 3

Bose Companion 3 User Manual

Bose Companion 3
25 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Aim the port
of
the module away from the wall to decrease bass or toward the wall to
increase bass;
in
either case, be sure it
is
at least 3 inches
(8
cm) from the wall.
Place the module away from heat sources (radiators, baseboard, quartz heater, etc.).
Adequate ventilation is necessary to prevent the module from overheating during use. Do
not block the openings on the back
of
the module, which provide ventilation for the built-in
circuitry.
Using the supplied audio input cable, you can place the module up to 6 feet
(2
m)
away
from the multimedia sound source. If you put the module farther away, use
an
audio input
extension cable available from any retail electronics store.
Positioning
the
satellite
speakers
These speakers are designed to sit upright on your desk, or be mounted on your monitor with
the supplied speaker brackets. The speakers are magnetically shielded to prevent
interference when they are on or near your monitor. Using the supplied speaker cables, you
can place the satellite speakers up to 6 feet
(2
m)
away from the module.
If
placing
your
speakers
on
the
desktop:
Attach the three small rubber feet to each satellite speaker as indicated by the indentations
on the bottom
of
each speaker.
Place speakers facing you, at
an
equal distance on either side
of
monitor.
Place both speakers a maximum
of
3 feet
(90
cm) from the edge
of
the screen, and at
approximately the same height.
A CAUTION: Choose a stable, level surface for the speakers. Vibration can cause the speakers
to
move, particularly on smooth surfaces like marble, glass,
or
highly polished wood.
If
needed, you
may
obtain additional rubber feet from
Bose®
Customer Service.
To
contact
Customer Service, refer to the address sheet included in the product carton.
If
mounting
speakers
on
your
monitor
(Figure 4):
Figure 4
Mounting the bracket
1.
Attach a pad to the right speaker
bracket (marked
R).
3.
Insert the speaker wire into the
center
of
the open bracket.
2.
Peel off one side
of
the mounting adhesive,
and attach it to the bracket.
4.
Move the bracket along the cord toward
the speaker.
7

Other manuals for Bose Companion 3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bose Companion 3 and is the answer not in the manual?

Bose Companion 3 Specifications

General IconGeneral
Audio output channels2.0 channels
Surround speaker weight400 g
Package weight9300 g
Weight and Dimensions IconWeight and Dimensions
Subwoofer weight6700 g
Subwoofer dimensions (WxDxH)217 x 348 x 172 mm
Satellite speaker dimensions (WxDxH)63 x 82 x 86 mm

Related product manuals