7
SPECIFICATIONS (CONT.)
PART LIST NOTES
1. The individual parts located on the PCBs are listed in the Electrical Part List.
2. This part is referenced for informational purposes only. It is not stocked as a repair part. Refer to
the next higher assembly for a replacement part.
3. This part is critical for safety purposes. Failure to use the Bose
®
recommended part may result
in a safety hazard and may void the regulatory certication.
Electrostatic Discharge Sensitive (ESDS) Device Handling
This unit contains ESDS devices. We recommend the following precautions when repairing, replacing or
transporting ESDS devices:
• Perform work at an electrically grounded work station.
• Wear wrist straps that connect to the station or heel straps that connect to conductive oor mats.
• Avoid touching the leads or contacts of ESDS devices or PC boards even if properly grounded.
Handle boards by the edges only.
• Transport or store ESDS devices in ESD protective bags, bins, or totes. Do not insert unprotected
devices into materials such as plastic, polystyrene foam, clear plastic bags, bubble wrap or plastic
trays.
ELECTRICAL SPECIFICATIONS
Mains Voltage 85 VAC-264 VAC 50/60 Hz
AC Power Consumption < 15 VA typical at 122 °F (50 °C) ambient
Mains ConnectorIEC 60320-C14 (Inlet)
Power Dissipation 12 W (41 BTU, 10 kcal)
PHYSICAL
Dimensions 44 mm x 483 mm x 215 mm (1.7" H x 19" W x 8.5" D)
Net Weight 2.6 kg (5.8 lb)
Operating Temperature32 °F - 122 °F (0 °C - 50 °C)
Cooling System Passive, side venting
GENERAL
PC Configuration SoftwareControlSpace® Designer™ software
Network ControlEthernet (RJ-45), 1Gb
RS-232/485 ports RS-232 (DTE) & Bose CC-16 (RS-485 master); 3.81 mm Phoenix Contact®, 3-pin
Audio Channel Capacity166 channels (20 analog, 8 AmpLink out, 64x64 Dante, 4 VoIP, 4 USB, 2 PSTN)
To Next Page
Loading...
Need help?
General
