6
SPECIFICATIONS
INTEGRATED DSP
Signal Processor/CPU32-bit fixed/floating-point DSP 456 MHz/ARM Cortex-A8 600MHz
Maximum Calculation 3.6 GIPS / 2.7 GFLOPS
Delay43 s
Audio Latency860 μs (analog in to analog out)
A/D and D/A Converters 24-bit
Sample Rate 48 kHz
ANALOG AUDIO INPUTS
Input Channels 12 balanced, mic/line level
Connectors, Input3.81 mm Phoenix Contact®, 6-pin
Input Impedance12 kΩ @ 1 kHz (with or without phantom power active)
Maximum Input Level +24 dBu
Equivalent Input Noise-118 dB at 48 dB gain setting
Phantom Power+48 VDC, 10 mA, selectable per input
Gain Settings0/14/24/32/48/54/64 dB
ANALOG AUDIO OUTPUTS
Output Channels 8 balanced, line level
Connectors 3.81 mm Phoenix Contact®, 6-pin
Output Impedance200 Ω
Maximum Output Level +24 dBu
AUDIO PERFORMANCE SPECIFICATIONS
Frequency Response20 Hz – 20 kHz (+0.3 dB/-0.1 dB)
THD+N0.002 % at +4 dBu (A-weighted/20 Hz – 20 kHz)
Channel Separation (Crosstalk)< -105 dB at +4 dBu input and output level, 1 kHz
Dynamic Range > 115 dB, A-weighted 20 Hz – 20 kHz, analog input to analog output
AUDIO OVER IP
Dante
™
RJ-45; 64 x 64 channels, primary/secondary (ControlSpace ports)
DIGITAL AUDIO OUTPUTS
AmpLink Output
RJ-45; 8 ultra-low latency < 100 μs, 48 kHz
COMMUNICATION PORTS
USB Device Micro-B type, stereo in/out, class-compliant
VoIP RJ-45; 2 lines, 2 instances per line
PSTN RJ-11; 1 line, Tx/Rx
USB HostType A. For future use
CONTROL INPUTS
Inputs (Control) 5 analog or digital inputs, 2 kΩ internal pull-up resistor to 5 V, 3.81 mm Phoenix Contact®, 6-pin
Analog Input Voltage Range 0 V to 3.3 V (maximum 5 V)
Digital Input Voltage Range 0 V to 3.3 V (threshold voltage = 1.6 V)
CONTROL OUTPUTS
Outputs (Control) 5 digital outputs, 3.81 mm Phoenix Contact®, 6-pin
Output Voltage High: 8 V (open circuit), 2.5 V @ 10 mA Low: < 1 V @ 100 mA, push-pull
INDICATORS AND CONTROLS
Display256 x 64 OLED with rotary encoder
LED Status IndicatorsPower/Status
To Next Page
Loading...
Need help?
General
