Bose L1 Model II User Manual

11
S
YSTEM SETUP
English Deutsch FrançaisDansk Español Italiano SvenskaNederlandsDansk Italiano SvenskaDeutsch NederlandsEnglish FrançaisEspañol
Connecting the B1 bass module
You can place the B1 bass module either vertically or horizontally on the floor. It fits neatly
bewteen the legs of the power stand.
1. Plug one end of the B1 bass module cable into one of the B1 connectors. Rotate the plug
clockwise to lock it in place. You should hear a soft click as it locks.
2. Plug the other end of the cable into the Bass Module Out connector on the power
stand. Rotate the plug clockwise to lock it.
Note: To disconnect a B1 cable, slide back the metal tab on the body of the plug, rotate the plug
counterclockwise, and pull it out of the connector.
Figure 7
B1 bass module
CAUTIONS:
• DO NOT connect a B1 bass module to two power stands at the same time.
• DO NOT connect any bass module other than the B1 to the power stand.
• DO NOT substitute the supplied cable with a 2-wire speaker cable. Use only the supplied
B1 bass module 4-wire cable to connect the B1 bass module to the power stand. The
power stand uses the signals on two of the wires to automatically sense how many B1
bass modules are connected.
B1 bass
module
cable
Bass Module Out
VeniceOG.book Page 11 Tuesday, January 16, 2007 1:28 PM

Bose L1 Model II Specifications

General

Product color	Black
Bass adjustment	Yes
Recommended usage	Studio
Multi-Room Streaming (MRS) support	No
Speaker type	-
Number of drivers	2
Speaker placement	Stand-mountable
Audio output channels	- channels
RMS rated power	- W
USB 2.0 ports quantity	1
Connectivity technology	Wired
Power source type	AC

Weight and Dimensions

Depth	450 mm
Width	260 mm
Height	381 mm
Weight	11380 g