DAY/ TIME
User Manual 28
Programmable Fan Mode
Programmable Fan Mode is selected by pressing
FAN until PROG appears in the display. It is only
available in programmable mode.
Programmable Fan Mode allows the user to run
the fan continuously during a selected program
event. To use this feature, select fan ON while
setting program events. (See “Setting Your
Program Schedule”, page 13).
Compressor Protection
Compressor protection is enabled/disabled
in the Installer Settings (See Installer Manual).
If enabled, this feature is automatically present in
cooling and/or heating modes.
This thermostat includes an automatic compressor protection delay to avoid potential damage to your system
from short cycling. This feature activates a short delay after turning off the system compressor.
Additionally, for multi-stage heat pump systems, this thermostat provides cold weather compressor protection by
locking out the compressor stage(s) of heating for a period of time after a power outage greater than 60 minutes.
This cold weather compressor protection can be manually overridden at any time by changing the system mode
to OFF momentarily, then back to HEAT.
To Next Page
Loading...
Need help?
General
