Page 70
Warnings and
Lift Operating
Instructions
Decal 27204
ADA Standee
and Interlock
Decal 19342
Non Lift-Posted Decals
To remove the masking, start
an edge and peel back slowly,
at a sharp angle directly over
the top of the decal.
Parking
Courtesy
Requested
Decal
#12375
Actual Size:
3" W. x 4-3/4" T.
Two Courtesy Requested decals
are supplied with all Braun lifts to
be posted on vehicle as desired.
Decals
TM
12375
Fairfield, NJ USA
Oslo, Norway
Clearwater, FL USA
Kitchener, Ontario Can.
Huntington Beach, CA USA
Rocklea, Queensland Aust.
"Providing Access to the World"
International Corporate Hdqrs: P.O. Box 310 Winamac, IN 46996 USA
1-800-THE LIFT (219) 946-6153 FAX: (219) 946-4670
Parking Court esy
Requested
Actual Size:
2-3/16" W. x 15/16" T.
Circuit Sentry
(100 A.) Label
Decal #18181
Installation
Instructions
Decal #18180
Supplied to be posted near the lift
control box mounting location (lift
posted also - see following page).
Posted on 100 ampere 12
volt Circuit Sentry #18189A.
Note: Decals #18182 and
#18180 posted on 24 volt
Circuit Centry #18190A.
Clean powder-coated surfaces
(or painted surfaces) with
isopropyl alcohol before decal
or antiskid application. Use a
clean cloth or paper towels.
DO NOT use oily shop rags.
Wipe surface free of residue
with dry portion of cleaning
cloth.
1. Attach lift power cable to
2. Attach battery lead cable to
3. Locate Circuit Sentry as specified in owner's/service
manual. Use self-tap screws to mount unit to
appropriate mounting surface. Sandwich flat
plastic between Circuit Sentry and mounting surface.
4. Attach battery lead cable to battery terminal.
auxiliary
battery
Installation Instructions
Note:
positive (+)
Circuit Sentry terminal.
Circuit Sentry terminal.
18180
This unit is designed to protect the electrical system on
all Braun hydraulic wheelchair lifts. In the event of failure,
wait 60 seconds. Then turn RESET lever to reset breaker.
18181
Rating: 100 Amps
The Braun
Circuit Sentry
CAUTION!
Turn RESET lever to reset breaker only!
Turning lever at any other time will result in damage.
Mask Removal: Pay close
attention to this mask
removal procedure when
posting die-cut logo decals.
W
A
RNING
Read manual before
operating lift. Call
1-800-THE LIFT to
receive operator's
manual. Failure to
do so may result in
serious bodily injury
and/or property
damage. Keep
manual in lift pouch.
25674
Oper
ual
M
an
a
t
o
r
'
s
Operators
Manual
Policy
Warning
Decal 25674
Actual Size:
1-1/2" W. x 3-1/4" T.
Posted on the lift
control box as shown.
Replace missing, worn
or illegible decals.
Failure to do so may
result in serious bodily
injury and/or property
damage.
W
A
RNING
The lift is only as safe as the operator.
Lift-posted decals are shown by mounting
location. Part numbers are provided for all
decals. Inspect your lift for any missing,
worn or illegible decals. Call 1-800-THE
LIFT for replacements.
Decal and Antiskid Application Procedure
Decals and Antiskid
OPERATING
INSTRUCTIONS
19342
Standees must
stand at center of platform (fully inside
yellow boundaries), grip handrails and
lower head to clear door jamb header.
Lift Interlocks
vary in type and operation. Interlock
(if equipped) must be operated as
instructed by transit authority.
Read warnings and operate lift as
outlined on LIFT OPERATING
INSTRUCTIONS decal. Lift operating
instructions apply to wheelchair
passengers and standees.
Standee Instructions:
Interlock Instructions:
U.S. Patent No. 6,065,924
Patents Pending
W
A
RNING
LIFT OPERATING
INSTRUCTIONS
• Read manual before operating lift.
• Load and unload on level surface
only.
• Engage vehicle parking brake before
operating lift.
• Provide adequate clearance outside
of vehicle to accommodate lift.
• Do not operate lift if you suspect lift
damage, wear or any abnormal
condition.
• Keep operator and bystanders clear
of area in which lift operates.
Whenever a wheelchair passenger
is on the platform, the:
• Passenger must be positioned
fully inside yellow boundaries
• Wheelchair brakes must be locked
• Roll stop(s) must be up
Failure to follow these rules may result
in serious bodily injury and/or property
damage.
OPEN DOOR(S) AND SECURE
TO UNFOLD PLATFORM:
Stand clear and press UNFOLD
switch until platform stops (reaches
floor level).
Note: In event platform does not
unfold, press FOLD switch to
release Lift-Tite™ latches.
TO UNLOAD PASSENGER:
1. Load passenger onto platform and
lock wheelchair brakes.
2. Press DOWN switch until entire
platform reaches ground level and
roll stop unfolds fully.
3. Unlock wheelchair brakes and unload
passenger from platform.
TO LOAD PASSENGER:
1. Load passenger onto platform and
lock wheelchair brakes.
2. Press UP switch to fold roll stop
up and raise platform to floor level.
3. Unlock wheelchair brakes and unload
passenger from platform.
TO FOLD PLATFORM:
Press FOLD switch until platform
stops. Release switch.
CLOSE DOOR(S)
27204
U.S. Patent No. 5,261,779
U.S. Patent No. 5,806,632
W
A
RNING
Read manual before
operating lift. Call
1-800-THE LIFT to
receive operator's
manual. Failure to
do so may result in
serious bodily injury
and/or property
damage. Keep
manual in lift pouch.
25674
Oper
ual
M
a
n
at
o
r's
To Next Page
Loading...
Need help?
General
