IMPORTANT SAFEGUARDS
11. The use of an accessory
attachment not recommended by the
manufacturer may cause a risk of fire,
electric shock, or injury to persons.
When using your equipment, basic safety
precautions should always be followed,
including the following :
1. Read and understand all
instructions before using. Pay
particular attention to areas where
this symbol
is shown.
12. Connect this appliance to a
grounded outlet.
13. Disconnect this unit from its source
of supply before replacing the projection
lamp.
2. Close supervision is necessary when
any appliance is used by or near
children. Do not leave appliance
unattended while in use.
14. This unit is equipped with optical
lenses and should not be exposed to
direct sunlight.
3. Care must be taken as burns can
occur from touching hot parts.
15. Keep ventilation openings free of
any obstructions.
4. Do not operate appliance with a
damaged cord or if the appliance has
been dropped or damaged - until it has
been examined by a qualified
serviceman.
16. This unit is connected by a special
cable that, if it is damaged, has to be
replaced by the same type of cable.
This cable can be ordered from your
local dealer and has to be installed by a
professional.
5. Position the cord so that it will not be
tripped over, pulled, or contact hot
surfaces.
6. If any extension cord is necessary, a
cord with a current rating at least equal
to that of the appliance should be used.
Cords rated for less amperage than the
appliance may overheat.
SAVE THESE INSTRUCTIONS
The information contained in this manual will
help you operate and maintain your
overhead projector.
7. Always unplug appliance from
electrical outlet before opening the
cover for cleaning, servicing, lamp
changing and when not in use. Never
yenk cord to pull plug from outlet. Grasp
plug and pull to disconnect.
8. Let appliance cool completely before
putting away or when replacing lamp.
UK ONLY
9. To reduce the risk of electric shock,
do not immerse this appliance in water
or other liquids.
Important!
The wires in this mains lead are coloured in
accordance with the following code:
- green/yellow: earth
10. To reduce the risk of electric shock,
do not disassemble this appliance, but
take it to a qualified technician when
service or repair work is required.
Incorrect reassembling can cause
electric shock when the appliance is
- blue: neutral
- brown live
used subsequently.
3
To Next Page
Loading...
Need help?
General
