WHEN CHANGING THE TREADLE OPERATION TO TIMER SWITCH
CON-ROL
• Turn off
dip
switch 2-8.
• When running a flap program, the machine will not operate on pressing the start switch unless the flap
presser is lowered.
• For standard sewing, the machine will operate on pressing the start switch after the folding plate has
operated.
• Set the MODE selector either
to
AUTOMATIC
or
to
MANUAL.
• Input programs with the MODE selector set
to
AUTOMATIC.
<Treadle operation>
~
1.
Press treadle 0 backwards
to
raise padding cloth presser foot springs R 8
and
L 0 .
2.
Release treadle 0
to
lower padding cloth presser foot springs R 8 and L 0 .
3.
Press treadle 0 forward
to
position 0
to
lower carriage feed arm L 8 .
4.
Continue pressing treadle 0 at position
1,
for 0.5 seconds,
to
lower carriage feed arm R 8 .
5.
Continue pressing treadle 0 at position
1,
for
1.
7 seconds,
to
lower binder 8 and operate the
folding plate.
* The folding plate will start
to
operate 0.25
to
0.35 seconds after
binder8is
lowered.
6.
Continue pressing treadle 0 at position
1,
for
1.5
seconds,
to
lower flap presser L 8 .
7. Continue pressing treadle 0 at position 1, for 1 second,
to
lower flap presser R • .
8. Press
START
switch 8
to
operate the carriage feed.
* The carriage feed and other mechanisms will not be reset even If the treadle is released at steps 3
to
7.
Press treadle 0 backwards
to
reset.
* If the MODE selector
Is
set
to
MANUAL, the carriage feed will operate without actual sewing.
* The sequence
of
carriage feed and flap presser operations (steps
3,
4,
6 and 7 above) can be
changed
by
setting the dip switches (see page 50).
-48-
To Next Page
Loading...
Need help?
General
