Brother CS6000XL User Manual

24
Memo
• This adjustment can be made to (Quilting
stippling stitch), decorative stitches, satin
stitches, and cross stitches� For details on the
built-in stitch patterns, refer to “Stitch Chart”
(http://s�brother/cmkag/)�
Brother Support Website
Information (Downloading Manuals)
Brother support website introduces a variety of
information about the product, such as sewing tips,
how to use optional accessories, and details on stitch
patterns�
Please visit us at http://s�brother/cmkag/ �
You can download “Sewing Guide” and “Stitch Chart”�
You can also download this Operation Manual from
the site�
Care and Maintenance
Restrictions on oiling
In order to prevent damaging this machine, it must not
be oiled by the user�
This machine was manufactured with the necessary
amount of oil applied to ensure correct operation,
making periodic oiling unnecessary�
If problems occur, such as difficulty turning the
handwheel or an unusual noise, immediately stop
using the machine, and contact your authorized
Brother dealer or the nearest Brother authorized
service center�
Precautions on storing the
machine
Do not store the machine in any of the locations
described below, otherwise damage to the machine
may result, for example, rust caused by condensation�
• Exposed to extremely high or low temperatures
• Exposed to extreme temperature changes
• Exposed to high humidity or steam
• Near a flame, heater or air conditioner
• Outdoors or exposed to direct sunlight
• Exposed to extremely dusty or oily environments
Note
• In order to extend the life of this machine,
periodically turn it on and use it�
Storing this machine for an extended period of time
without using it may reduce its efficiency�
Cleaning the machine surface
CAUTION
• Unplug the power supply cord before
cleaning the machine, otherwise injuries or
an electric shock may occur�
Cleaning the race
Sewing performance will suffer if dust collects in the
bobbin case�
CAUTION
• Make sure you unplug the machine before
you clean it� Otherwise, you may get an
electric shock or be injured�
1
Turn off the machine and unplug the power cord�
2
Raise the needle and remove the presser foot�
3
Remove the needle
(1)
and the presser foot
holder
(2)
�
Next, loosen the two screws (
3
) and remove the
needle plate�
1
2
3
Screwdriver
Screwdriver
Note
• Be careful not to drop the removed screws in
the machine�
4
Remove the bobbin case, and remove any dust
from the race and its surrounding area�
Bobbin case
Race
Cleaning brush
*
Do not put oil on the bobbin case�
Note
• Compressed can air is not recommended to be
used�

Brother CS6000XL Specifications

General

Brand	Brother
Model	CS6000XL
Category	Sewing Machine
Language	English