> MONTHLY MAINTENANCE PROCEDURE
Monthly Maintenance has to be performed on top of the Daily & Weekly Maintenance.
The purpose is to keep the printer in the best status for printing without problems.
Remember that it is better to spent 15 minutes every month than to be with machine
down for several days !
We recommend you to do the cleaning and greasing of the CR shaft, cleaning CR rail
and a good visual inspection of the printer.
Unscrew the knob on the felt supports and
remove them.
Pour a little alcohol (95% or higher) on a
cloth and clean the rail thoroughly.
Remove and replace the felts on the bottom
of the felt supports in accordance with the
“Maintenance Parts Exchange”.
Pour alcohol (95% or higher) on a cloth and
clean the carriage shaft thoroughly.
When clean, coat the shaft with Molykote 30
white grease.
Don’t forget to grease between the 2 bearings
in the middle of the carriage.
CLEAN the rail with ALCOHOL 95°
Reattach both felt supports and tighten the knob screw.
Add also a little bit of Molykote 30 grease at the bronze sprocket of the CR Motor.
+
SPARE PARTS NUMBER:
SB3229001
MONTHLY MAINTENANCE
CARRIAGE SHAFT CLEANING & GREASING
CARRIAGE RAIL CLEANING
After cleaning & greasing the Carriage Shaft and cleaning the Carriage Rail
please, always perform a CR Speed Adjustment on the machine !
!
6
To Next Page
Loading...
Need help?
General
