15
=Loading and Unloading Film
2
Open the back cover.
•
Slide down the back cover release
lever and open the back.
1
Turn the Mode Dial to any
setting except <:>.
3
Insert the film cartridge at a
slight angle.
4
Align the film leader edge with
the <§> mark.
•
Hold down the film cartridge while
pulling out the film leader. If you
pull out the film leader too much,
rewind it back into the film
cartridge.
Loading Film
After you load the film, the camera first winds the entire roll onto the
camera’s take-up spool. With DX-coded film, the camera
automatically sets the film’s ISO speed. Then each time a picture is
taken, one frame of film is rewound back into the film cartridge. The
frame counter shows always number of shots remaining.
Wrong
5
Close the back cover.
•
Close the back cover until it snaps
shut.
s Film prewind will start and there will
be a shutter-release sound about
10 sec. later. The <=> icon and
frame count will also be displayed
on the LCD panel.
s During the film prewind, the ISO
speed will be displayed on the LCD
panel.
To Next Page
Loading...
Need help?
General
