Canon imagePROGRAF iPF6300S Basic Guide No.1 Basic Guide

3
Troubleshooting
Printing Does Not Start
Phenomenon
Phenomenon Cause Corrective Action
The Data lamp on the Control
Panel does not light up
The printer does not respond even
if print jobs are sent
1.
2.
1.
2.
Ink Filling.. is displayed
Make sure the power cord is securely plugged in, all
the way. Press the Power button to turn on the printer.
Set Pause Print to Off .
In Windows, select the printer by clicking Select
Printer or Printer in the printing dialog box and try
printing again.
In Windows, restart the print job as follows.
In Mac OS X, open the dialog box of the printer driver,
select the printer from the list of Printer , and try
printing again.
Select the printer icon in the Printers and Faxes (or
Printers ) window.
Clear Pause Printing in the File menu to restart the
print job.
In Mac OS X, restart the print job as follows.
Click Print & Fax . (This is identified as Printer
Setup Utility or Print Center in other versions of
Mac OS X.)
Select the printer, and then Resume Printer (or
Start Jobs ) in the Printers menu to restart the print
job.
Wait until the system has been filled with ink.
The printer is not on.
In the Control Panel menu, Pause
Print is On .
The target printer was not selected
when printing. (The printer is in
Sleep mode.)
The print job is paused. (The
printer is in Sleep mode.)
The printer was forced off during
operation.
Cause Corrective Action
The display screen indicates
Agitating
The time for agitation varies depending on how long
the printer was off. (Between about 30 seconds and
two minutes.)
Ink agitation is in progress.
(→"Pausing Printing," User's Guide)
You have selected Save in mail
box in Output Method on the
printer.
Print the job saved on the printer's hard disk.
Print jobs are pending. Manage the jobs on hold and print as needed.
(→"Printing Saved Jobs," User's Guide)
(→"Managing Pending Jobs (Printing or Deleting Jobs
on Hold)," User's Guide)
Please wait until ink agitation is finished.
Roller marks are left across the
trailing edge of paper
The paper was removed without
pressing the OK button after
printing from the Front Paper
Feed Slot .
Following the instructions displayed, press the OK
button, and after removing the paper, press the OK
button again.
Wipe the rollers to clean them.
(→
, If Paper is Soiled)
(→"Cleaning the Paper Retainer," User's Guide)
Margins are wide Rolls are advanced a specific
amount before cutting to prevent
problems with cutting and paper
ejection.
This operation is normal.

Canon imagePROGRAF iPF6300S Basic Guide No.1 Specifications

General

Brand	Canon
Model	imagePROGRAF iPF6300S Basic Guide No.1
Category	Printer
Language	English