23
If the Platen inside the Top Cover becomes dirty, it may soil the underside of paper. We recommend cleaning the
Platen after borderless printing or printing on small paper.
•
If the Ejection Guide is dirty, it may soil the edge of the paper when the paper is cut. We recommend cleaning the
Ejection Guide even if it does not appear dirty, because it may actually be covered with paper dust.
•
If the Tab Selection screen is not displayed, press the Menu button.•
1
2
3
4
5
Clean inside the Top Cover about once a month to maintain better printing quality and help prevent problems.
Also clean inside the Top Cover in the following situations to ensure optimal operation.
On the Tab Selection screen of the Control Panel , press
◄ or ► to select the Settings/Adj. tab (
).
Press the OK button.
If the printed surface or the underside of paper is dirty after printing•
After you have used up a roll•
After borderless printing•
After printing on small paper•
If you have replaced the roll•
After printing on paper that generates a lot of cutting debris•
After printing on paper that generates a lot of paper dust•
If the message Blue platen switch is dirty. is displayed•
If Paper is Soiled
Clean inside the top cover of the printer as follows.
The Set./Adj. Menu is displayed.
Press ▲ or ▼ to select Maintenance , and then press the
OK button.
Press ▲ or ▼ to select Clean Platen , and then press the
OK button.
A message on the Display Screen requests you to open
the Top Cover .
Open the Top Cover .
678
Tot.Print Area(m2):
Maint.C Remain.: 80%
Ready
OK:Setting/Adj. Menu
To Next Page
Loading...
Need help?
General