42
Error Messages
Error Message Cause Corrective Action
The paper is too small. When Detect Mismatch in the
Control Panel menu is set to
Pause or Hold Job , paper smaller
than the size specified in the
printer driver is loaded.
Press ▲ or ▼ to select Print , and then press the OK
button to resume printing.
However, note that this error may cause paper jams
and affect the printing quality.
Adjust the paper size setting in the printer driver to
match the size loaded in the printer as follows.
Press ▲ or ▼ to select Stop Printing , and then
press the OK button to stop printing.
1.
Change the paper size setting in the printer driver to
the size loaded in the printer and try printing again.
2.
Replace the loaded paper with paper of a size that
matches the size setting in the printer driver as
follows.
Press ▲ or ▼ to select Change Paper , and then
press the OK button to stop printing.
1.
Replace the loaded paper to match the paper width
setting in the printer driver and try printing again.
2.
When Detect Mismatch in the
Control Panel menu is set to
Warning , paper smaller than the
size specified in the printer driver
is loaded.
You can continue to print, but note that this error may
cause problems in the printing results.
No maintenance cartridge. The Maintenance Cartridge is not
installed.
Install the Maintenance Cartridge .
No Maintenance Cartridge
capacity.
The Maintenance Cartridge cannot
absorb enough ink for Printhead
cleaning or other operation.
After confirming that the printer has stopped
operating, replace the Maintenance Cartridge .
Maint. cart. The level is low The Maintenance Cartridge is
almost full.
You can continue to print, but prepare a new
Maintenance Cartridge
to use when the message for
replacement is displayed.
Wrong maintenance cartridge. A Maintenance Cartridge for
a different model of printer is
installed.
Replace it with the Maintenance Cartridge for your
particular model.
(→
, Replacing the Maintenance Cartridge)
(→
, Replacing the Maintenance Cartridge)
Maintenance cartridge problem. An incompatible or used
Maintenance Cartridge has been
installed.
Install an unused Maintenance Cartridge specified for
use with the printer.
Maintenance cartridge full. The Maintenance Cartridge is full. After confirming that the printer has stopped
operating, replace the Maintenance Cartridge .
(→
, Replacing the Maintenance Cartridge)
(→
, Replacing the Maintenance Cartridge)