( 5 / 21 )
3. ERROR DISPLAY
Errors are displayed by the LEDs, and ink low warnings are displayed by the Status Monitor.
3-1. Operator Call Error (LED Blinking in Orange)
LED
blinking
Error Corrective action
2 times Paper out Set paper, and press the Resume/Cancel button
to feed the paper.
3 times Paper jam Remove the jammed paper, and press the
Resume/Cancel button.
4 times Ink tank not installed Re-install the ink tanks, and close the access
cover.
5 times Print head not installed or failure has
occurred in the print head.
(Non-supported print head (see page 4) is
installed or print head EEPROM data is
abnormal.)
Install the print head, and close the access cover.
Or, confirm the print head is “QY6-0054-000” and
perform re-installation. If not recovered, with the
print head installed, power the printer off and on.
8 times Waste ink absorber full or platen waste ink
absorber full warning (approx. 95% of the
maximum capacity)
Pressing the Resume/Cancel button will exit the
error, and enable printing.
3-2. Service Call Error (LED Blinking in Orange and Green Alternately)
LED
blinking
Error Corrective Action
2 times Carriage error Replace the printer as it has failed.
3 times LF error Replace the printer as it has failed.
7 times Waste ink absorber full or platen waste ink
absorber full
Replace the printer as it has failed.
8 times Print head temperature rise error Replace the printer as it has failed.
9 times EEPROM error Replace the printer as it has failed.
10 times No print head detected excepting print head
replacement (during printing)
Replace the printer as it has failed.
To Next Page
Loading...
Need help?
General
