Zoom Lever
(See page 27)
Controls
(See page 6)
Lens
Lens Cap
Be sure to remove the lens cap during
projection. The cap can deform or fire
can occur.
Built-in Security Slot ( )*
Focus Ring
(See page 27)
Adjustable Tilt Foot Lock Button
(See page 26)
Adjustable Tilt Foot
(See page 26)
Remote sensor
(See page 10)
Ve
ntilation (inlet) / Filter Cover
(See page 55)
D
o n
ot block this vent.
Troubles or fire can result.
Two filters on LV-7265/LV-7260
One filter on LV-X7
Ventilation (inlet)
Front/Top
AC Input
Connect the supplied power cord’s two-pin plug here, and
plug the other end into an active wall outlet. (See page 22)
Ma
in Power Switch
When you plug the supplied power cord into an active wall outlet
and turn on the Main Power, the POWER indicator turns orange
and the projector is in standby mode.
(See page 23)
Remote
sensor
(LV-7265 only)
(See page 10)
Ter
minal Panel
(See page 7)
Mona
ural Speaker
(LV-7265: 5W)
(LV-7260/LV-X7: 1W)
Rear
* This security slot supports the MicroSaver ® Security System. MicroSaver ® is a registered trademark of
Kensington Microware Inc. The logo is trademarked and owned by Kensington Microware Inc.
Ventilation (outlet)
Heated air is exhausted from here.
Do not block this vent. Troubles or
fire can result.
1. Introduction
To Next Page
Loading...
Need help?
General
