81
ENGLISH
Control Commands
You can control this projector by sending commands via CONTROL port or LAN port.
System Requirement
CONTROL port
**When using HDBaseT.
LAN port/HDBaseT input terminal
Control Command
Connection Cable 9-pin RS-232-C Cable (Crossover)
Communication Mode RS-232-C asynchronous, half-duplex communication
Baud Rate 19200 bps/9600bps**
Character Length 8 bit
Parity Check None
Stop Bits 1 bit
Flow Control None
Connection System TCP/IP Connection
Port 33336
Function
Read/
Write
Operation Command (ASCII) Note
Power
W Power On POWER=ON<CR>
Enable during
“Standby” state.
W Power Off POWER=OFF<CR>
R Power Status GET=POWER<CR>
Enable during any
power state.
[Warming up]
g:POWER=OFF2ON
[Cooling down]
g:POWER=ON2OFF
Source
Selection
W Computer1 INPUT=DSUB1<CR>
W Computer2 INPUT=DSUB2<CR>
W HDMI/MHL INPUT=HDMI1<CR>
W HDMI2 INPUT=HDMI2<CR>
W HDBaseT INPUT=HDBASET<CR>
W Video INPUT=VIDEO<CR>
W S-Video INPUT=S-VIDEO<CR>
R Current source GET=INPUT<CR>
To Next Page
Loading...
Need help?
General
