96
English
Subwoofer Setup [SUB]
In this menu you can adjust the phase of a connected subwoofer and activate different Sub Stereo Modes [SSM] and adjust the crossover
frequency between a subwoofer and the front speakers. This menu item is only available if a subwoofer (Smart or Analog) is activated in the
Speakerconfiguration menu.
Sub Phase [PHA]
Use this function Sub Phase to change the phase of a connected subwoofer between 0 degree (factory setting) and 180 degree (phase
inverted) relative to the other speakers. Try a phase shift of 180 degree in case the bass level at the selected crossover frequency in the
menu Xover Small Speakers [XOV] seems to be much too low or completely off. This function works for both, wirelessly and wired sub-
woofers. This function is only available if a subwoofer (Smart or Analog) has been selected in the menu Speakerconfiguration [SPC].
To set the subwoofer’s phase to 180 degree resp. back to 0 degree, please do the following:
1
To enter the menu, press the "M" button.
2
Use the " " or " " button to navigate into the menu Speaker Setup [SPS] and confirm with the "OK" button.
3
Use the " " or " " button to navigate into the menu Subwoofer Setup [SUB] and confirm with the "OK" button.
4
Use the " " or " " button select the menu item Sub Phase [PHA] and confirm with the "OK" button.
5
Change the setting using the "+" or "-" key between 0 degree [0] and 180 degree [180] and confirm with the "OK" button.
6
To exit the menu, press the Menu button "M".
Sub Stereo [SSM]
If you are using large speakers (Speakerconfig [SPC] = Large) you can select the Sub Stereo Mode "Parallel" to have the full music signal
(including the bass) routed to the front speakers (FL, FR) and have the bass routed additionally to the subwoofer in the playmode Ste-
reo.
In the Sub Stereo Mode "Xover" you can split the signal between the subwoofer and the large front speakers using a crossover. The cros-
sover frequency can be adjusted in the menu item Stereo Sub Xover [SSX]in values between 40 Hz and 100 Hz. This function is only avai-
lable if a subwoofer (Smart or Analog) is activated in the Speakerconfiguration menu. This function is set to Off [OFF] as factory setting.
To activate or change the Sub Stereo Mode please do as follows:
1
To enter the menu, press the "M" button.
2
Confirm the first menu item Speaker Setup [SPS] with the "OK button.
3
Use the " " or " " button to select the menu item Subwoofer Setup [SUB] and confirm with the "OK" button.
4
Use the " " or " " button to select the menu item Sub Stereo Mode [SSM] and confirm with the "OK" button.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
