Before Getting
Started...
This section provides an overview of the watch
and introduces convenient ways it can be
used.
Note
●
The illustrations included in this
operation guide have been created to
facilitate explanation. An illustration
may differ somewhat from the item it
represents.
Watch Face Items
A
Last signal receive result/auto time
adjustment setting status
The second hand points to [Y(YES)] or
[N(NO)] to indicate the result of the last auto
time adjustment operation based on time
signal reception or connection with a phone.
[Y(YES)]: Auto time adjustment successful
[N(NO)]: Auto time adjustment failed
The second hand points to [Y(YES)] or
[N(NO)] to indicate if auto time adjustment is
enabled or disabled.
[Y(YES)]: Auto time adjustment enabled
[N(NO)]: Auto time adjustment disabled
B
[RC]
The second hand points to this mark while
calibration signal reception is in progress.
C
[C]
The second hand points to this mark while
there is a connection between the watch and
a phone.
D
Summer time setting
The second hand points to the current
summer time setting.
Using the Crown
●
Fast Forward/Fast Reverse
Second click
First click
Normal timekeeping
Crown
Important!
●
To prevent loss of water resistance
and/or
damage due to impact, be sure
to push the crown in to its normal
position after you are finished using it.
●
When pushing the crown back in, take
care not to apply too much force.
After pulling out the crown to the first or second
click,
rotating it quickly in succession in either
direction will start a fast forward or fast reverse
operation. While a fast forward operation is in
progress, quickly rotating the crown in
succession again will increase the speed even
further.
●
Stopping Fast Forward/Fast Reverse
Rotate the crown in the direction opposite that
of the ongoing operation or press any button.
Note
●
If
you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Day Indicator Movement
●
It can take anywhere from about 10 to 40
seconds for the day indicator to change
after timekeeping reaches midnight.
●
The day may not be indicated correctly
while the watch’s crown is pulled out.
Solar Charging
This watch runs on power supplied from a
rechargeable (secondary) battery that is
charged by a solar panel. The solar panel is
integrated into the face of the watch, and
power is generated whenever the face is
exposed to light.
●
Charging the Watch
When you are not wearing the watch, put it in
a location where it is exposed to bright light.
While you are wearing the watch, make sure
that its face (solar panel) is not blocked from
the
light by the sleeve of your clothing. Power
generation efficiency is reduced even when
the face of the watch is blocked only partially.
Important!
●
Depending on light intensity and local
conditions,
the watch may become hot
to the touch when exposed to light for
charging. Take care to avoid burn
injury after charging. Also, avoid
charging the watch under high-
temperature conditions like the ones
described below.
ー
On the dashboard of a vehicle
parked in the sun
ー
Near an incandescent light bulb or
other source of heat
ー
Under direct sunlight or in other hot
areas for long periods
Operation Guide 5596
2
To Next Page
Loading...
Need help?
General
