90
Using the Camera with a Computer
. To connect the camera to your computer and save files
1. Turn off the camera and then
use the micro USB cable that
comes with the camera to
connect it to your Macintosh.
• For details about connecting to
the camera and precautions
when connecting, see page 22.
2. Turn on the camera.
• The camera’s back lamp will light green or amber at this time. In this mode,
your Macintosh recognizes the memory card loaded in the camera (or the
camera’s built-in memory if it does not have a memory card loaded) as a drive.
The appearance of the drive icon depends on the Mac OS version you are
using.
• The first time you connect the camera to your Macintosh with the USB cable,
an error message may appear on your computer. If this happens, disconnect
and then reconnect the USB cable.
3. Double-click the camera’s drive icon.
The camera’s back lamp will light green at this time. In this mode, your Macintosh
recognizes the memory card loaded in the camera (or the camera’s built-in
memory if it does not have a memory card loaded) as a drive. The appearance of
the drive icon depends on the Mac OS version you are using.
4. Drag the “DCIM” folder to the folder to which you want to copy it.
5. After the copy operation is complete, drag the drive icon to Trash.
6. Disconnect the camera from the computer.
On the camera, press [p] (Power) to turn off the camera. After checking to make
sure that the back lamp is unlit or lit red, disconnect the USB cable.
USB
Micro USB cable
(included with camera)
[USB] port
To Next Page
Loading...
Need help?
General
