102
Using the Hybrid-GPS
1. Press [ý] (MAP) to enter the MAP mode.
• Each press of [ý] (MAP) toggles between the User Image mode and the
Photogenic Spot mode.
2. Use the procedures below to move a user image mark or a photogenic
spot mark near the center of the display’s radar screen lines.
• Moving a user image mark or photogenic spot mark to the center of the radar
screen causes the corresponding image (user image or photogenic spot
image) to move to the top of the image list to the right of the map.
• The images that appear in the list on the screen are displayed in sequence
starting from the landmark that is closest to the center of the radar screen and
then radiating outwards in a clockwise direction.
MAP Mode Operation
To scroll the map
Use [8], [2], [4], and [6].
• To return your current location to the center of the
screen, press [ù] (Current Location). This will cause
(current location) to appear in the center of the radar
screen.
•[ù] (Current Location) is disabled while “Off” is
selected for the “GPS” setting (page 92).
To change the
scale of the map
Slide the zoom controller.
w (Wide Angle):
Zooms out (reduces the
scale) so a wider area of the
map is visible.
z (Telephoto):
Zooms in (increases the
scale) so a smaller area of
the map is visible.
Zoom controller
To Next Page
Loading...
Need help?
General
