93
Using the Hybrid-GPS
While “On” is selected for the “Record Lat/Long” setting, location information (latitude,
longitude, camera aiming direction) as measured by the Hybrid-GPS will be recorded
along with the image data (snapshots and movies).
1. In the REC mode, press [MENU].
2. On the “Set Up” tab, select “Record Lat/Long” and then press [6].
3. Use [8] and [2] to select “On” and then press [SET].
4. Press the shutter button (if you are shooting a snapshot) or [0] (Movie)
(if you are shooting a movie).
This will record the image along with the location information (latitude, longitude,
direction) for your current location.
• In the case of a snapshot, the location information is recorded when you press
the shutter button all the way down. For a movie, the location information is
recorded when you press [0] (Movie).
. Checking GPS Wave Conditions
An icon on the display shows current GPS wave conditions. Be sure to check this
icon before recording an image.
Recording Location Information with Image Data
(Record Lat/Long)
Icon GPS Wave Conditions
GPS satellite waves being received. GPS measurement location
information can be recorded with image data.
GPS satellite wave reception is poor, so GPS measurement location
information cannot be recorded with image data. In this case, motion
sensor location information will be recorded with image data.
GPS satellite waves cannot reach your location, so GPS position
information cannot be recorded with an image. The camera can, however,
save position information produced by the motion sensor.
GPS is turned off (page 92).
To Next Page
Loading...
Need help?
General
