123
Using the Camera with a Computer
4. Turn off the camera
and then use the USB
cable that comes with
the camera to connect
it to your computer.
• The camera does not
draw power over the
USB cable. Check the
battery level before
connecting and make
sure it is not too low.
• Make sure that you
insert the cable
connector into the USB/
AV port until you feel it
click securely into place.
Failure to insert the
connector fully can
result in poor
communication or
malfunction.
• Note that even while the connector is fully inserted, you still will be able to see
the metal part of the connector as shown in the illustration.
• When connecting the USB cable to a USB port, make
sure you align the connector correctly with the port.
• Your computer may not be able to recognize the camera if
you connect via a USB hub. Always connect directly to the
computer’s USB port.
5. Turn on the camera
6. Windows 7, Windows Vista users: Click “Start” and then “Computer”.
Windows XP users: Click “Start” and then “My Computer”.
7. Double-click “Removable Disk”.
• Your computer recognizes the memory card loaded in the camera (or built-in
memory if there is no card) as a removable disk.
USB port
USB cable
(included with camera)
Making sure that the 6 mark on the camera is aligned
with the 4 mark of the USB cable connector, connect
the cable to the camera.
[USB/AV]
port
Large connector
Small connector
To Next Page
Loading...
Need help?
General
