107
Viewing Snapshots and Movies
Use a commercially available HDMI cable to
connect the camera to the TV. For information
about playback, see the procedure starting
from step 2 under “Viewing Snapshots and
Movies on a TV Screen” on page 105.
• Use a commercially available HDMI cable that is marked with the logo shown to the
right.
IMPORTANT!
• Output to a TV is not supported while the camera is in the REC mode.
NOTE
• Use a HDMI cable that with a plug that is compatible with the camera’s HDMI mini
connector on one end, and a plug that is compatible with your TV’s HDMI
connector on the other end.
• Proper image and/or audio output and other operations may not be possible with
some devices.
• Connecting the camera to the HDMI connector of another device can damage both
the camera and the other device. Never connect two HDMI output connectors to
each other.
• Make sure that the camera is turned off before plugging in or unplugging the cable.
Check the user documentation that comes with the TV for information about
requirements before plugging into or unplugging from the TV.
• When cables are connected to both the USB/AV port and the HDMI output
connector, the HDMI output connector connection is given priority.
• Disconnect the HDMI cable when you are not using HDMI output. The camera’s
monitor screen may not operate normally while the HDMI cable is connected.
• Audio is stereo.
• Some TVs may not be able to output images and/or audio correctly.
• Audio is initially output by the camera at maximum volume. When you first start
displaying images, set the TV volume control at a relatively low level and then
adjust it as required.
Viewing High-quality Movies on a Hi-Vision Television
HDMI connector
HDMI cable (commercially available)
HDMI mini connector
HDMI input
HDMI output
(Mini)
Terminal cover
To Next Page
Loading...
Need help?
General
