118
Viewing Snapshots and Movies
• Pressing [SET] will lock the current zoom factor for the on-screen image. You
can then use [4] and [6] to scroll between images, using the same zoom
factor. Pressing [SET] again will unlock the zoom factor and allow you to use
[8], [2], [4] and [6] to move around the currently displayed images. This
function cannot be used while viewing CS group images or movies. Also, CS
group images and movies will not appear when you are scrolling images with
[4] and [6].
1. In the PLAY mode, rotate the zoom controller
towards w (]).
Use [8], [2], [4] and [6] to move the selection
boundary around the image menu.
To view a particular image, use [8], [2], [4], or [6] to
move the selection boundary to the image you want and
then press [SET].
• In the case of a movie or a continuous shutter (CS)
file, the first frame of the file will be displayed.
• A question mark (?) will be displayed for images that cannot be displayed for
some reason.
1. Use the optionally available AV cable (EMC-8A) to connect the camera
to the TV.
• For details about connecting to the camera and precautions when connecting,
see page 17.
• Make sure that the camera is turned off before plugging in or unplugging the
cable. Check the user documentation that comes with the TV for information
about requirements before plugging into or unplugging from the TV.
Displaying the Image Menu
Viewing Snapshots and Movies on a TV Screen
Boundary
Yellow
AV cable (EMC-8A)
Red
VIDEO IN jack (yellow)
AUDIO IN jack (red)
TV
White
AUDIO IN jack (white)
Video Audio
To Next Page
Loading...
Need help?
General
