— 11 —
Data items
F1 F6
Performing Data Transfer Operation
Connect the two units and then perform the following procedures.
Receiving unit
To set up the calculator to receive data, press
F2
(RECV) while the data communication main menu is
displayed.
F2
(RECV)
The calculator enters a data receive standby mode and waits for data to arrive. Actual data receive starts as
soon as data is sent from the sending unit.
Sending unit
To set up the calculator to send data, press
F1
(TRAN) while the data communication main menu is
displayed.
F1
(TRAN)
Press the function key that corresponds to the type of data you want to send.
F1
(SEL) ..... Selects data items and sends
F2
(CRNT).. Selects data items from among previously selected data items and sends
F6
(BACK) .. All memory contents, including mode settings
• To send selected data items
Press
F1
(SEL) or
F2
(CRNT) to display a data item selection screen.
F1
(SEL) or
F2
(CRNT)
F1
(SEL)......Selects data item where cursor is located.
F6
(TRAN)...Sends selected data items.
F1
F2
F6
To Next Page
Loading...
Need help?
General
