E-17
6. Remove the battery pack as shown in the fi gure.
7. Install the replacement battery pack following steps 3
to 5 of the battery pack installation procedure.
Precautions for Use
• Remove the battery pack by pulling up the removal tape. Do not pull up with
excessive force as this may result in damage.
• In the Hot Swap mode, even if the battery pack is removed, your work state is saved
up to 4 minutes with the memory (RAM) backup function.
The memory (RAM) backup time may decrease depending on the backup battery
charging level.
• In the Hot Swap mode, the Smart Device will not respond even if you press the
Power key.
To exit Hot Swap mode, open the battery cover and then close it again.
• In case of replacing the battery pack without selecting the Hot Swap mode, you
cannot perform normal operations for a while.
• After replacing the battery pack, the message “Check the battery cover!!!” is
displayed. This message is displayed regardless of whether the battery cover has been
completely closed or not.
• Do not replace the SIM card or microSD card while in Hot Swap mode. Shut down
the Smart Device before replacing the SIM card or microSD card.
Installing and Removing the AC Adapter
You must install the adequate plug in the AC adapter for the Smart Device according to the
region where the Smart Device is used.
Installation
1. Insert the protruding part of the AC adapter plug into
the recessed part in the AC adapter top (
) and push
until it clicks into place (
).
“TOP” should be
facing upwards
To Next Page
Loading...
Need help?
General